Ecobee – How to add a SmartSensor and Optimizing Placement in the home

Category: Sensors > SmartSensor

Answer:

This article will guide you through pairing your SmartSensor and provide recommendations for optimal placement throughout your home.

To Pair a SmartSensor

On the ecobee App:

1. Tap the + sign on the Home screen.
2. Tap Add a Device.
3. Select Room Sensor.
4. Select SmartSensor.
5. Tap Let's Get Started.
6. Scan the QR code on the sensor's pull tab.
7. If needed, manually enter the pairing code.
8. Pull the tab to begin pairing.
9. Ensure the SmartSensor is at least 24 inches away from the ecobee thermostat during pairing.
10. Select a name from the list or create a custom name.
11. Select the thermostat you want to pair the sensor with.
12. Select the Comfort Settings in which the sensor will participate.
13. Review the placement recommendations.
14. Tap Next.
15. Tap Done or Add Another Device.

To Unpair a SmartSensor or Room Sensor

On the Thermostat:

1. Go to Main Menu > General Settings > Sensors.
2. Select the sensor you want to remove.
3. Select the Trash icon.
4. Select Unpair.

For Smart Thermostat Lite and Essential Owners

1. Go to Main Menu > Sensors.
2. Select the sensor you want to remove.
3. Select the Trash icon.
4. Select Unpair.

Good to Know

• SmartSensor uses a 3-volt CR2477 battery.
• Battery life is up to 5 years.
• SmartSensor is not compatible with CR2477N batteries.
• During pairing, the SmartSensor must be at least 24 inches away from the thermostat.

How to Place a SmartSensor in Your Home

Placement on a Table, Shelf, or Open Surface

Height

• Position the sensor approximately four feet above the floor.

Direct Sunlight

• Avoid direct sunlight.

Exterior Walls and Windows

• Keep the sensor away from exterior walls and windows.

Vents, Fans, and Drafts

• Avoid placement near vents, fans, or drafty areas.

Electrical Devices

• Keep the sensor away from TVs, lamps, and the ecobee thermostat.

Wall-Mounted Placement

Selecting the Location

• Choose an interior wall approximately five feet above the floor.

Avoid Vents and Windows

• Do not place the sensor near vents or windows.

Cleaning the Surface

• Clean the wall surface before mounting.

Attachment Options

Adhesive Mount

• Press the adhesive mount firmly against the wall for approximately 10 seconds.

Screw Mount

• Use a #4-22 flat head Phillips screw (not included).
• Recommended screw length is 1 inch.
• Mount through drywall as needed.